Introduction of Hexagon Cross Bolt

Hexagon Cross Bolt are commonly used screws in machinery, which have the advantages of easy tightening and disassembly, and not easy to slip corners. Hexagonal wrenches are generally 90 degrees, with one end long and one end short. When using short-side screws, holding the long side can save a lot of force and tighten the screws better. The manufacturing cost of the outer hexagon head bolt is much lower than that of the inner hexagon head bolt. Its advantage is that the screw head is thinner than the inner hexagon, and the inner hexagon cannot be replaced in some places.

Hexagon Cross Bolt are divided into outer hexagon bolts and inner hexagon screws, which are usually used to fasten mechanical equipment. Hexagon head bolts are externally threaded fasteners with hexagon heads, which are designed to be turned with a wrench.

Hexagon Cross Bolt have round heads on the outside and concave hexagons in the middle, while the outer hex bolts are common hexagon head bolts. The hexagon socket head bolt looks like a ‘7’. It is cut into two sections with hexagonal steel bars and bent 90 degrees to form a socket wrench.

Hexagon Cross Bolt, also known as socket head screws or socket head bolts, are screws with a hexagonal inner hole on the head, which can be tightened or loosened by inserting a hexagonal wrench into the inner hole. Commonly used hexagon socket head bolts are cylinder head screws, the head diameter of which is about 1.5 times the main diameter of the thread. Other types of heads include bottom cover screws for aesthetically pleasing surfaces and countersunk screws for tapered threaded holes. The counterbore design allows the screw head to rotate without being exposed to the surface of the fixed object, so it is often used in places where the surface is small and the use of traditional wrenches is inconvenient.

Hexagon Cross Bolt are generally made of stainless steel, and a layer of antioxidant is formed on the surface. The material is added with molybdenum, which has good corrosion resistance, wear resistance and rust resistance, and the strength can reach 4.8. It is often used in general cold room processing and drawing, and its corrosion resistance is well used in the production of sea water and some chemical media. The round stainless steel of hexagon head bolts can play a good anti-corrosion effect even when used in damp water. There is no residual burr on the surface, and it is not easy to slip when fixed and rotating. The deep design of the thread is more uniform during use, and the thread teeth are more uniform. Sharp, so as to achieve a firm effect.